PHP socket_create_pair() Function: Usage and Examples

Creates a pair of connected sockets suitable for local IPC. This guide demonstrates its use in PHP code and explains when the result or side effect needs extra checks.

What It Does

Creates a pair of connected sockets suitable for local IPC.

Syntax and Parameters

The examples below show a real call to socket_create_pair with suitable arguments. Read the function call in context: its connection, handle, input data or other prerequisites are created before use.

Requirements: Sockets extension; operating-system networking support.

These examples are for an isolated development environment. Hostnames, credentials and remote paths must be replaced with your approved configuration.

Example 1: Core Behavior

Use local loopback or a connected socket pair to avoid unintended public network exposure.

<?php
$pair = [];
$ok = socket_create_pair(AF_UNIX, SOCK_STREAM, 0, $pair);
echo $ok ? "Connected local pair" : "Failed";
if ($ok) { socket_close($pair[0]); socket_close($pair[1]); }

Observe the returned value or changed resource state. A successful function call can still require additional checks before a higher-level operation is considered successful.

Example 2: Alternative or Failure Case

The operation may return a status or a partial byte count depending on timing and transport.

<?php
$pair = [];
$ok = socket_create_pair(AF_UNIX, SOCK_DGRAM, 0, $pair);
echo $ok ? "Connected local pair" : "Failed";
if ($ok) { socket_close($pair[0]); socket_close($pair[1]); }

Compare the different inputs, environment assumptions or result checks. Do not use a transport-level success value as proof that all business-level requirements were met.

Practical Example: Applying the Rule

Apply explicit timeouts and check errors before integrating the code into a long-running server.

<?php
$pair = [];
$ok = socket_create_pair(AF_UNIX, SOCK_STREAM, 0, $pair);
echo $ok ? "Connected local pair" : "Failed";
if ($ok) { socket_set_option($pair[0], SOL_SOCKET, SO_RCVTIMEO, ["sec" => 1, "usec" => 0]); socket_close($pair[0]); socket_close($pair[1]); }

In an application, convert low-level failures into controlled responses and log only non-sensitive diagnostic context.

Important Behavior and Edge Cases

AF_UNIX socket pairs may not be available on every operating system.

Network operations can block or read/write only part of a message. Treat end-of-stream, timeout and transient errors separately.

Comparison with Related Functions or Patterns

Common Beginner Mistakes

Key Takeaways

• Creates a pair of connected sockets suitable for local IPC.
• AF_UNIX socket pairs may not be available on every operating system.
• socket_create constructs an unconnected socket.

Select this API or pattern based on its documented behavior and the trust boundaries in your own application, and test all external integrations against their actual deployments.